Doorbell and Host diagnostic registers could return 0 even after 3 retries and that leads to occasional resets of the controllers, hence increased the retry count to thirty.
Fixes: b899202901a8 ("mpt3sas: Add separate function for aero doorbell reads") Cc: stable@vger.kernel.org Signed-off-by: Ranjan Kumar ranjan.kumar@broadcom.com --- drivers/scsi/mpt3sas/mpt3sas_base.c | 53 ++++++++++++++++------------- drivers/scsi/mpt3sas/mpt3sas_base.h | 11 +++++- 2 files changed, 39 insertions(+), 25 deletions(-)
diff --git a/drivers/scsi/mpt3sas/mpt3sas_base.c b/drivers/scsi/mpt3sas/mpt3sas_base.c index 53f5492579cb..efc9bc48db6f 100644 --- a/drivers/scsi/mpt3sas/mpt3sas_base.c +++ b/drivers/scsi/mpt3sas/mpt3sas_base.c @@ -196,25 +196,27 @@ module_param_call(mpt3sas_fwfault_debug, _scsih_set_fwfault_debug, /** * _base_readl_aero - retry readl for max three times. * @addr: MPT Fusion system interface register address - * - * Retry the readl() for max three times if it gets zero value + *@retry_count: max no of retry + + * Retry the readl() for max thirty times if it gets zero value * while reading the system interface register. */ + static inline u32 -_base_readl_aero(const volatile void __iomem *addr) +_base_readl_aero(const volatile void __iomem *addr, u8 retry_count) { u32 i = 0, ret_val;
do { ret_val = readl(addr); i++; - } while (ret_val == 0 && i < 3); + } while (ret_val == 0 && i < retry_count);
return ret_val; }
static inline u32 -_base_readl(const volatile void __iomem *addr) +_base_readl(const volatile void __iomem *addr, u8 retry_count) { return readl(addr); } @@ -940,7 +942,7 @@ mpt3sas_halt_firmware(struct MPT3SAS_ADAPTER *ioc)
dump_stack();
- doorbell = ioc->base_readl(&ioc->chip->Doorbell); + doorbell = ioc->base_readl(&ioc->chip->Doorbell, READL_RETRY_COUNT); if ((doorbell & MPI2_IOC_STATE_MASK) == MPI2_IOC_STATE_FAULT) { mpt3sas_print_fault_code(ioc, doorbell & MPI2_DOORBELL_DATA_MASK); @@ -1617,10 +1619,10 @@ mpt3sas_base_mask_interrupts(struct MPT3SAS_ADAPTER *ioc) u32 him_register;
ioc->mask_interrupts = 1; - him_register = ioc->base_readl(&ioc->chip->HostInterruptMask); + him_register = ioc->base_readl(&ioc->chip->HostInterruptMask, READL_RETRY_SHORT_COUNT); him_register |= MPI2_HIM_DIM + MPI2_HIM_RIM + MPI2_HIM_RESET_IRQ_MASK; writel(him_register, &ioc->chip->HostInterruptMask); - ioc->base_readl(&ioc->chip->HostInterruptMask); + ioc->base_readl(&ioc->chip->HostInterruptMask, READL_RETRY_SHORT_COUNT); }
/** @@ -1634,7 +1636,7 @@ mpt3sas_base_unmask_interrupts(struct MPT3SAS_ADAPTER *ioc) { u32 him_register;
- him_register = ioc->base_readl(&ioc->chip->HostInterruptMask); + him_register = ioc->base_readl(&ioc->chip->HostInterruptMask, READL_RETRY_SHORT_COUNT); him_register &= ~MPI2_HIM_RIM; writel(him_register, &ioc->chip->HostInterruptMask); ioc->mask_interrupts = 0; @@ -6686,7 +6688,7 @@ mpt3sas_base_get_iocstate(struct MPT3SAS_ADAPTER *ioc, int cooked) { u32 s, sc;
- s = ioc->base_readl(&ioc->chip->Doorbell); + s = ioc->base_readl(&ioc->chip->Doorbell, READL_RETRY_COUNT); sc = s & MPI2_IOC_STATE_MASK; return cooked ? sc : s; } @@ -6760,7 +6762,8 @@ _base_wait_for_doorbell_int(struct MPT3SAS_ADAPTER *ioc, int timeout) count = 0; cntdn = 1000 * timeout; do { - int_status = ioc->base_readl(&ioc->chip->HostInterruptStatus); + int_status = ioc->base_readl(&ioc->chip->HostInterruptStatus, + READL_RETRY_SHORT_COUNT); if (int_status & MPI2_HIS_IOC2SYS_DB_STATUS) { dhsprintk(ioc, ioc_info(ioc, "%s: successful count(%d), timeout(%d)\n", @@ -6786,7 +6789,8 @@ _base_spin_on_doorbell_int(struct MPT3SAS_ADAPTER *ioc, int timeout) count = 0; cntdn = 2000 * timeout; do { - int_status = ioc->base_readl(&ioc->chip->HostInterruptStatus); + int_status = ioc->base_readl(&ioc->chip->HostInterruptStatus, + READL_RETRY_SHORT_COUNT); if (int_status & MPI2_HIS_IOC2SYS_DB_STATUS) { dhsprintk(ioc, ioc_info(ioc, "%s: successful count(%d), timeout(%d)\n", @@ -6824,14 +6828,15 @@ _base_wait_for_doorbell_ack(struct MPT3SAS_ADAPTER *ioc, int timeout) count = 0; cntdn = 1000 * timeout; do { - int_status = ioc->base_readl(&ioc->chip->HostInterruptStatus); + int_status = ioc->base_readl(&ioc->chip->HostInterruptStatus, + READL_RETRY_SHORT_COUNT); if (!(int_status & MPI2_HIS_SYS2IOC_DB_STATUS)) { dhsprintk(ioc, ioc_info(ioc, "%s: successful count(%d), timeout(%d)\n", __func__, count, timeout)); return 0; } else if (int_status & MPI2_HIS_IOC2SYS_DB_STATUS) { - doorbell = ioc->base_readl(&ioc->chip->Doorbell); + doorbell = ioc->base_readl(&ioc->chip->Doorbell, READL_RETRY_COUNT); if ((doorbell & MPI2_IOC_STATE_MASK) == MPI2_IOC_STATE_FAULT) { mpt3sas_print_fault_code(ioc, doorbell); @@ -6871,7 +6876,7 @@ _base_wait_for_doorbell_not_used(struct MPT3SAS_ADAPTER *ioc, int timeout) count = 0; cntdn = 1000 * timeout; do { - doorbell_reg = ioc->base_readl(&ioc->chip->Doorbell); + doorbell_reg = ioc->base_readl(&ioc->chip->Doorbell, READL_RETRY_COUNT); if (!(doorbell_reg & MPI2_DOORBELL_USED)) { dhsprintk(ioc, ioc_info(ioc, "%s: successful count(%d), timeout(%d)\n", @@ -7019,13 +7024,13 @@ _base_handshake_req_reply_wait(struct MPT3SAS_ADAPTER *ioc, int request_bytes, __le32 *mfp;
/* make sure doorbell is not in use */ - if ((ioc->base_readl(&ioc->chip->Doorbell) & MPI2_DOORBELL_USED)) { + if ((ioc->base_readl(&ioc->chip->Doorbell, READL_RETRY_COUNT) & MPI2_DOORBELL_USED)) { ioc_err(ioc, "doorbell is in use (line=%d)\n", __LINE__); return -EFAULT; }
/* clear pending doorbell interrupts from previous state changes */ - if (ioc->base_readl(&ioc->chip->HostInterruptStatus) & + if (ioc->base_readl(&ioc->chip->HostInterruptStatus, READL_RETRY_SHORT_COUNT) & MPI2_HIS_IOC2SYS_DB_STATUS) writel(0, &ioc->chip->HostInterruptStatus);
@@ -7068,7 +7073,7 @@ _base_handshake_req_reply_wait(struct MPT3SAS_ADAPTER *ioc, int request_bytes, }
/* read the first two 16-bits, it gives the total length of the reply */ - reply[0] = le16_to_cpu(ioc->base_readl(&ioc->chip->Doorbell) + reply[0] = le16_to_cpu(ioc->base_readl(&ioc->chip->Doorbell, READL_RETRY_COUNT) & MPI2_DOORBELL_DATA_MASK); writel(0, &ioc->chip->HostInterruptStatus); if ((_base_wait_for_doorbell_int(ioc, 5))) { @@ -7076,7 +7081,7 @@ _base_handshake_req_reply_wait(struct MPT3SAS_ADAPTER *ioc, int request_bytes, __LINE__); return -EFAULT; } - reply[1] = le16_to_cpu(ioc->base_readl(&ioc->chip->Doorbell) + reply[1] = le16_to_cpu(ioc->base_readl(&ioc->chip->Doorbell, READL_RETRY_COUNT) & MPI2_DOORBELL_DATA_MASK); writel(0, &ioc->chip->HostInterruptStatus);
@@ -7087,10 +7092,10 @@ _base_handshake_req_reply_wait(struct MPT3SAS_ADAPTER *ioc, int request_bytes, return -EFAULT; } if (i >= reply_bytes/2) /* overflow case */ - ioc->base_readl(&ioc->chip->Doorbell); + ioc->base_readl(&ioc->chip->Doorbell, READL_RETRY_COUNT); else reply[i] = le16_to_cpu( - ioc->base_readl(&ioc->chip->Doorbell) + ioc->base_readl(&ioc->chip->Doorbell, READL_RETRY_COUNT) & MPI2_DOORBELL_DATA_MASK); writel(0, &ioc->chip->HostInterruptStatus); } @@ -7949,14 +7954,14 @@ _base_diag_reset(struct MPT3SAS_ADAPTER *ioc) goto out; }
- host_diagnostic = ioc->base_readl(&ioc->chip->HostDiagnostic); + host_diagnostic = ioc->base_readl(&ioc->chip->HostDiagnostic, READL_RETRY_COUNT); drsprintk(ioc, ioc_info(ioc, "wrote magic sequence: count(%d), host_diagnostic(0x%08x)\n", count, host_diagnostic));
} while ((host_diagnostic & MPI2_DIAG_DIAG_WRITE_ENABLE) == 0);
- hcb_size = ioc->base_readl(&ioc->chip->HCBSize); + hcb_size = ioc->base_readl(&ioc->chip->HCBSize, READL_RETRY_SHORT_COUNT);
drsprintk(ioc, ioc_info(ioc, "diag reset: issued\n")); writel(host_diagnostic | MPI2_DIAG_RESET_ADAPTER, @@ -7969,7 +7974,7 @@ _base_diag_reset(struct MPT3SAS_ADAPTER *ioc) for (count = 0; count < (300000000 / MPI2_HARD_RESET_PCIE_SECOND_READ_DELAY_MICRO_SEC); count++) {
- host_diagnostic = ioc->base_readl(&ioc->chip->HostDiagnostic); + host_diagnostic = ioc->base_readl(&ioc->chip->HostDiagnostic, READL_RETRY_COUNT);
if (host_diagnostic == 0xFFFFFFFF) { ioc_info(ioc, diff --git a/drivers/scsi/mpt3sas/mpt3sas_base.h b/drivers/scsi/mpt3sas/mpt3sas_base.h index 05364aa15ecd..b4e57b89915d 100644 --- a/drivers/scsi/mpt3sas/mpt3sas_base.h +++ b/drivers/scsi/mpt3sas/mpt3sas_base.h @@ -160,6 +160,15 @@
#define IOC_OPERATIONAL_WAIT_COUNT 10
+/* + *Due to hardware specific behaviour + *retry count is increased from 3 to 30. + *Delay is not needed as retry count fulfill + *the desired requirement + */ +#define READL_RETRY_COUNT 30 +#define READL_RETRY_SHORT_COUNT 3 + /* * NVMe defines */ @@ -994,7 +1003,7 @@ typedef void (*NVME_BUILD_PRP)(struct MPT3SAS_ADAPTER *ioc, u16 smid, typedef void (*PUT_SMID_IO_FP_HIP) (struct MPT3SAS_ADAPTER *ioc, u16 smid, u16 funcdep); typedef void (*PUT_SMID_DEFAULT) (struct MPT3SAS_ADAPTER *ioc, u16 smid); -typedef u32 (*BASE_READ_REG) (const volatile void __iomem *addr); +typedef u32 (*BASE_READ_REG) (const volatile void __iomem *addr, u8 retry_count); /* * To get high iops reply queue's msix index when high iops mode is enabled * else get the msix index of general reply queues.