[ Upstream commit db1b5bc047b3cadaedab3826bba82c3d9e023c4b ]
Interrupt handler checked THRE bit (transmitter holding register empty) in LSR to detect if TX fifo is empty. In case when there is only receive interrupts the TX handling got called because THRE bit in LSR is set when there is no transmission (FIFO empty). TX handling caused TX stop, which in RS-485 half-duplex mode actually resets receiver FIFO. This is not desired during reception because of possible data loss.
The fix is to check if THRI is set in IER in addition of the TX fifo status. THRI in IER is set when TX is started and cleared when TX is stopped. This ensures that TX handling is only called when there is really transmission on going and an interrupt for THRE and not when there are only RX interrupts.
Signed-off-by: Kimmo Rautkoski ext-kimmo.rautkoski@vaisala.com Signed-off-by: Greg Kroah-Hartman gregkh@linuxfoundation.org Signed-off-by: Sasha Levin sashal@kernel.org --- drivers/tty/serial/8250/8250_port.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/drivers/tty/serial/8250/8250_port.c b/drivers/tty/serial/8250/8250_port.c index 84474f06dbcf..8f1233324586 100644 --- a/drivers/tty/serial/8250/8250_port.c +++ b/drivers/tty/serial/8250/8250_port.c @@ -1819,7 +1819,8 @@ int serial8250_handle_irq(struct uart_port *port, unsigned int iir) status = serial8250_rx_chars(up, status); } serial8250_modem_status(up); - if ((!up->dma || up->dma->tx_err) && (status & UART_LSR_THRE)) + if ((!up->dma || up->dma->tx_err) && (status & UART_LSR_THRE) && + (up->ier & UART_IER_THRI)) serial8250_tx_chars(up);
spin_unlock_irqrestore(&port->lock, flags);