There are a few more bits in the GSWIP_MII_CFG register for which we
did rely on the boot-loader (or the hardware defaults) to set them up
properly.
For some external RMII PHYs we need to select the GSWIP_MII_CFG_RMII_CLK
bit and also we should un-set it for non-RMII PHYs. The GSWIP IP also
supports in-band auto-negotiation for RGMII PHYs. Set or unset the
corresponding bit depending on the auto-negotiation mode.
Clear the xMII isolation bit when set at initialization time if it was
previously set by the bootloader. Not doing so could lead to no traffic
(neither RX nor TX) on a port with this bit set.
While here, also add the GSWIP_MII_CFG_RESET bit. We don't need to
manage it because this bit is self-clearning when set. We still add it
here to get a better overview of the GSWIP_MII_CFG register.
Fixes: 14fceff4771e51 ("net: dsa: Add Lantiq / Intel DSA driver for vrx200")
Cc: stable(a)vger.kernel.org
Suggested-by: Hauke Mehrtens <hauke(a)hauke-m.de>
Acked-by: Hauke Mehrtens <hauke(a)hauke-m.de>
Signed-off-by: Martin Blumenstingl <martin.blumenstingl(a)googlemail.com>
---
drivers/net/dsa/lantiq_gswip.c | 22 +++++++++++++++++++---
1 file changed, 19 insertions(+), 3 deletions(-)
diff --git a/drivers/net/dsa/lantiq_gswip.c b/drivers/net/dsa/lantiq_gswip.c
index 47ea3a8c90a4..f330035ed85b 100644
--- a/drivers/net/dsa/lantiq_gswip.c
+++ b/drivers/net/dsa/lantiq_gswip.c
@@ -93,8 +93,12 @@
/* GSWIP MII Registers */
#define GSWIP_MII_CFGp(p) (0x2 * (p))
+#define GSWIP_MII_CFG_RESET BIT(15)
#define GSWIP_MII_CFG_EN BIT(14)
+#define GSWIP_MII_CFG_ISOLATE BIT(13)
#define GSWIP_MII_CFG_LDCLKDIS BIT(12)
+#define GSWIP_MII_CFG_RGMII_IBS BIT(8)
+#define GSWIP_MII_CFG_RMII_CLK BIT(7)
#define GSWIP_MII_CFG_MODE_MIIP 0x0
#define GSWIP_MII_CFG_MODE_MIIM 0x1
#define GSWIP_MII_CFG_MODE_RMIIP 0x2
@@ -821,9 +825,11 @@ static int gswip_setup(struct dsa_switch *ds)
/* Configure the MDIO Clock 2.5 MHz */
gswip_mdio_mask(priv, 0xff, 0x09, GSWIP_MDIO_MDC_CFG1);
- /* Disable the xMII link */
+ /* Disable the xMII interface and clear it's isolation bit */
for (i = 0; i < priv->hw_info->max_ports; i++)
- gswip_mii_mask_cfg(priv, GSWIP_MII_CFG_EN, 0, i);
+ gswip_mii_mask_cfg(priv,
+ GSWIP_MII_CFG_EN | GSWIP_MII_CFG_ISOLATE,
+ 0, i);
/* enable special tag insertion on cpu port */
gswip_switch_mask(priv, 0, GSWIP_FDMA_PCTRL_STEN,
@@ -1597,19 +1603,29 @@ static void gswip_phylink_mac_config(struct dsa_switch *ds, int port,
break;
case PHY_INTERFACE_MODE_RMII:
miicfg |= GSWIP_MII_CFG_MODE_RMIIM;
+
+ /* Configure the RMII clock as output: */
+ miicfg |= GSWIP_MII_CFG_RMII_CLK;
break;
case PHY_INTERFACE_MODE_RGMII:
case PHY_INTERFACE_MODE_RGMII_ID:
case PHY_INTERFACE_MODE_RGMII_RXID:
case PHY_INTERFACE_MODE_RGMII_TXID:
miicfg |= GSWIP_MII_CFG_MODE_RGMII;
+
+ if (phylink_autoneg_inband(mode))
+ miicfg |= GSWIP_MII_CFG_RGMII_IBS;
break;
default:
dev_err(ds->dev,
"Unsupported interface: %d\n", state->interface);
return;
}
- gswip_mii_mask_cfg(priv, GSWIP_MII_CFG_MODE_MASK, miicfg, port);
+
+ gswip_mii_mask_cfg(priv,
+ GSWIP_MII_CFG_MODE_MASK | GSWIP_MII_CFG_RMII_CLK |
+ GSWIP_MII_CFG_RGMII_IBS | GSWIP_MII_CFG_LDCLKDIS,
+ miicfg, port);
gswip_port_set_link(priv, port, state->link);
gswip_port_set_speed(priv, port, state->speed, state->interface);
--
2.31.1
Commit 8cdddd182bd7 ("ACPI: processor: Fix CPU0 wakeup in
acpi_idle_play_dead()") tried to fix CPU0 hotplug breakage by copying
wakeup_cpu0() + start_cpu0() logic from hlt_play_dead()//mwait_play_dead()
into acpi_idle_play_dead(). The problem is that these functions are not
exported to modules so when CONFIG_ACPI_PROCESSOR=m build fails.
The issue could've been fixed by exporting both wakeup_cpu0()/start_cpu0()
(the later from assembly) but it seems putting the whole pattern into a
new function and exporting it instead is better.
Reported-by: kernel test robot <lkp(a)intel.com>
Fixes: 8cdddd182bd7 ("CPI: processor: Fix CPU0 wakeup in acpi_idle_play_dead()")
Cc: <stable(a)vger.kernel.org> # 5.10+
Signed-off-by: Vitaly Kuznetsov <vkuznets(a)redhat.com>
---
Changes since v2:
- Use proper kerneldoc format [Rafael J. Wysocki]
---
arch/x86/include/asm/smp.h | 2 +-
arch/x86/kernel/smpboot.c | 26 ++++++++++++--------------
drivers/acpi/processor_idle.c | 4 +---
3 files changed, 14 insertions(+), 18 deletions(-)
diff --git a/arch/x86/include/asm/smp.h b/arch/x86/include/asm/smp.h
index 57ef2094af93..630ff08532be 100644
--- a/arch/x86/include/asm/smp.h
+++ b/arch/x86/include/asm/smp.h
@@ -132,7 +132,7 @@ void native_play_dead(void);
void play_dead_common(void);
void wbinvd_on_cpu(int cpu);
int wbinvd_on_all_cpus(void);
-bool wakeup_cpu0(void);
+void cond_wakeup_cpu0(void);
void native_smp_send_reschedule(int cpu);
void native_send_call_func_ipi(const struct cpumask *mask);
diff --git a/arch/x86/kernel/smpboot.c b/arch/x86/kernel/smpboot.c
index f877150a91da..16703c35a944 100644
--- a/arch/x86/kernel/smpboot.c
+++ b/arch/x86/kernel/smpboot.c
@@ -1659,13 +1659,17 @@ void play_dead_common(void)
local_irq_disable();
}
-bool wakeup_cpu0(void)
+/**
+ * cond_wakeup_cpu0 - Wake up CPU0 if needed.
+ *
+ * If NMI wants to wake up CPU0, start CPU0.
+ */
+void cond_wakeup_cpu0(void)
{
if (smp_processor_id() == 0 && enable_start_cpu0)
- return true;
-
- return false;
+ start_cpu0();
}
+EXPORT_SYMBOL_GPL(cond_wakeup_cpu0);
/*
* We need to flush the caches before going to sleep, lest we have
@@ -1734,11 +1738,8 @@ static inline void mwait_play_dead(void)
__monitor(mwait_ptr, 0, 0);
mb();
__mwait(eax, 0);
- /*
- * If NMI wants to wake up CPU0, start CPU0.
- */
- if (wakeup_cpu0())
- start_cpu0();
+
+ cond_wakeup_cpu0();
}
}
@@ -1749,11 +1750,8 @@ void hlt_play_dead(void)
while (1) {
native_halt();
- /*
- * If NMI wants to wake up CPU0, start CPU0.
- */
- if (wakeup_cpu0())
- start_cpu0();
+
+ cond_wakeup_cpu0();
}
}
diff --git a/drivers/acpi/processor_idle.c b/drivers/acpi/processor_idle.c
index 768a6b4d2368..4e2d76b8b697 100644
--- a/drivers/acpi/processor_idle.c
+++ b/drivers/acpi/processor_idle.c
@@ -544,9 +544,7 @@ static int acpi_idle_play_dead(struct cpuidle_device *dev, int index)
return -ENODEV;
#if defined(CONFIG_X86) && defined(CONFIG_HOTPLUG_CPU)
- /* If NMI wants to wake up CPU0, start CPU0. */
- if (wakeup_cpu0())
- start_cpu0();
+ cond_wakeup_cpu0();
#endif
}
--
2.30.2