This is a followup on 44117a1d1732 ("serial: core: mark port as
initialized after successful IRQ change").
Nikola has been using autoconfig via setserial and reported a crash
similar to what I fixed in the earlier mentioned commit. Here I do the
same fixup for the autoconfig. I wasn't sure that this is the right
approach. Nikola confirmed that it fixes his crash.
Fixes: b3b576461864 ("tty: serial_core: convert uart_open to use tty_port_open")
Link: http://lkml.kernel.org/r/20180131072000.GD1853@localhost.localdomain
Reported-by: Nikola Ciprich <nikola.ciprich(a)linuxbox.cz>
Tested-by: Nikola Ciprich <nikola.ciprich(a)linuxbox.cz>
Cc: Johan Hovold <johan(a)kernel.org>
Cc: Nikola Ciprich <nikola.ciprich(a)linuxbox.cz>
Cc: <stable(a)vger.kernel.org>
Signed-off-by: Sebastian Andrzej Siewior <bigeasy(a)linutronix.de>
---
drivers/tty/serial/serial_core.c | 2 ++
1 file changed, 2 insertions(+)
diff --git a/drivers/tty/serial/serial_core.c b/drivers/tty/serial/serial_core.c
index c8dde56b532b..35b9201db3b4 100644
--- a/drivers/tty/serial/serial_core.c
+++ b/drivers/tty/serial/serial_core.c
@@ -1144,6 +1144,8 @@ static int uart_do_autoconfig(struct tty_struct *tty,struct uart_state *state)
uport->ops->config_port(uport, flags);
ret = uart_startup(tty, state, 1);
+ if (ret == 0)
+ tty_port_set_initialized(port, true);
if (ret > 0)
ret = 0;
}
--
2.15.1
On Sat, Feb 03, 2018 at 09:35:26PM +0100, Pavel Machek wrote:
>On Sat 2018-02-03 18:00:59, Sasha Levin wrote:
>> From: Matthieu CASTET <matthieu.castet(a)parrot.com>
>>
>> [ Upstream commit 2b83ff96f51d0b039c4561b9f95c824d7bddb85c ]
>>
>> With the current code, the following sequence won't work :
>> echo timer > trigger
>>
>> echo 0 > delay_off
>> * at this point we call
>> ** led_delay_off_store
>> ** led_blink_set
>> *** stop timer
>> ** led_blink_setup
>> ** led_set_software_blink
>> *** if !delay_on, led off
>> *** if !delay_off, set led_set_brightness_nosleep <--- LED_BLINK_SW is set but timer is stop
>> *** otherwise start timer/set LED_BLINK_SW flag
>>
>> echo xxx > brightness
>> * led_set_brightness
>> ** if LED_BLINK_SW
>> *** if brightness=0, led off
>> *** else apply brightness if next timer <--- timer is stop, and will never apply new setting
>> ** otherwise set led_set_brightness_nosleep
>>
>> To fix that, when we delete the timer, we should clear LED_BLINK_SW.
>
>Can you run the tests on the affected stable kernels? I have feeling
>that the problem described might not be present there.
Hm, I don't seem to have HW to test that out. Maybe someone else does?
--
Thanks,
Sasha