From: Frank Rowand frank.rowand@sony.com
An August 2021 RFC patch [1] to create the KTAP Specification resulted in some discussion of possible items to add to the specification. The conversation ended without completing the document.
Progress resumed with a December 2021 RFC patch [2] to add a KTAP Specification file (Version 1) to the Linux kernel. Many of the suggestions from the August 2021 discussion were not included in Version 1. This patch series is intended to revisit some of the suggestions from the August 2021 discussion.
Patch 1 changes the Specification version to "2-rc" to indicate that following patches are not yet accepted into a final version 2.
Patch 2 is an example of a simple change to the Specification. The change does not change the content of the Specification, but updates a formatting directive as suggested by the Documentation maintainer.
I intend to take some specific suggestions from the August 2021 discussion to create stand-alone RFC patches to the Specification instead of adding them as additional patches in this series. The intent is to focus discussion on a single area of the Specification in each patch email thread.
[1] https://lore.kernel.org/r/CA+GJov6tdjvY9x12JsJT14qn6c7NViJxqaJk+r-K1YJzPggFD... [2] https://lore.kernel.org/r/20211207190251.18426-1-davidgow@google.com
Frank Rowand (2): Documentation: dev-tools: KTAP spec change version to 2-rc Documentation: dev-tools: use literal block instead of code-block
Documentation/dev-tools/ktap.rst | 20 +++++++++----------- 1 file changed, 9 insertions(+), 11 deletions(-)