Hi Breno,
On 16/08/2024 15:24, Breno Leitao wrote:
Adds a selftest that creates two virtual interfaces, assigns one to a new namespace, and assigns IP addresses to both.
It listens on the destination interface using socat and configures a dynamic target on netconsole, pointing to the destination IP address.
The test then checks if the message was received properly on the destination interface.
Signed-off-by: Breno Leitao leitao@debian.org
Changelog:
v4:
- Avoid sleeping in waiting for sockets and files (Matthieu Baerts)
- Some other improvements (Matthieu Baerts)
- Add configfs as a dependency (Jakub)
Thank you for the new version!
It looks good to me, but again, my review mainly focused on the Bash-related stuff, not on the netconsole test itself.
I just have one question below, but not blocking.
(...)
diff --git a/tools/testing/selftests/drivers/net/netcons_basic.sh b/tools/testing/selftests/drivers/net/netcons_basic.sh new file mode 100755 index 000000000000..5c3686af1fe8 --- /dev/null +++ b/tools/testing/selftests/drivers/net/netcons_basic.sh @@ -0,0 +1,249 @@
(...)
+check_file_size() {
- local file="$1"
- if [[ ! -f "$file" ]]; then
# File might not exist yetreturn 1- fi
- # Get file size
- local size=$(stat -c %s "$file" 2>/dev/null)
- # Check if stat command succeeded
- if [[ $? -ne 0 ]]; then
return 1- fi
- # Check if size is greater than zero
- if [[ "$size" -gt 0 ]]; then
return 0 # file size > 0- else
return 1 # file size == 0- fi
+}
(...)
+# Wait until socat saves the file to disk +busywait "${BUSYWAIT_TIMEOUT}" check_file_size "${OUTPUT_FILE}"
It looks like your 'check_file_size' helper is a reimplementation of 'test -s <FILE>', no? Can you not simply use:
busywait "${BUSYWAIT_TIMEOUT}" test -s "${OUTPUT_FILE}"
Apart from that, the rest looks good to me!
Acked-by: Matthieu Baerts (NGI0) matttbe@kernel.org
Cheers, Matt