On 5/19/25 01:58, Viresh Kumar wrote:
On 30-04-25, 17:14, Swapnil Sapkal wrote:
In cpufreq basic selftests, one of the testcases is to read all cpufreq sysfs files and print the values. This testcase assumes all the cpufreq sysfs files have read permissions. However certain cpufreq sysfs files (eg. stats/reset) are write only files and this testcase errors out when it is not able to read the file. Similarily, there is one more testcase which reads the cpufreq sysfs file data and write it back to same file. This testcase also errors out for sysfs files without read permission. Fix these testcases by adding proper read permission checks.
Can you share how you ran the test?
Reported-by: Narasimhan V narasimhan.v@amd.com Signed-off-by: Swapnil Sapkal swapnil.sapkal@amd.com
tools/testing/selftests/cpufreq/cpufreq.sh | 15 +++++++++++---- 1 file changed, 11 insertions(+), 4 deletions(-)
diff --git a/tools/testing/selftests/cpufreq/cpufreq.sh b/tools/testing/selftests/cpufreq/cpufreq.sh index e350c521b467..3484fa34e8d8 100755 --- a/tools/testing/selftests/cpufreq/cpufreq.sh +++ b/tools/testing/selftests/cpufreq/cpufreq.sh @@ -52,7 +52,14 @@ read_cpufreq_files_in_dir() for file in $files; do if [ -f $1/$file ]; then printf "$file:"
cat $1/$file
#file is readable ?
local rfile=$(ls -l $1/$file | awk '$1 ~ /^.*r.*/ { print $NF; }')
if [ ! -z $rfile ]; then
cat $1/$file
else
printf "$file is not readable\n"
fi
What about:
if [ -r $1/$file ]; then cat $1/$file else printf "$file is not readable\n" fi
thanks, -- Shuah