On Wed, 8 Sep 2021 17:30:24 +0000 Machnikowski, Maciej wrote:
Lane0 ------------- |\ Pin0 RefN ____ ------------- | |-----------------| | synced clk | |-----------------| EEC |------------------ ------------- |/ PinN RefM|____ | Lane N MUX
To get the full info a port needs to know the EEC state and which lane is used as a source (or rather - my lane or any other).
EEC here is what the PHY documentation calls "Cleanup PLL" right?
The lane -> Pin mapping is buried in the PHY/MAC, but the source of frequency is in the EEC.
Not sure what "source of frequency" means here. There's a lot of frequencies here.
What's even more - the Pin->Ref mapping is board specific.
Breaking down the system into components we have:
Port A.1 Rx lanes A.2 Rx pins (outputs) A.3 Rx clk divider B.1 Tx lanes B.2 Tx pins (inputs)
ECC C.1 Inputs C.2 Outputs C.3 PLL state
In the most general case we want to be able to: map recovered clocks to PHY output pins (A.1 <> A.2) set freq div on the recovered clock (A.2 <> A.3) set the priorities of inputs on ECC (C.1) read the ECC state (C.3) control outputs of the ECC (C.2) select the clock source for port Tx (B.2 <> B.1)
As you said, pin -> ref mapping is board specific, so the API should not assume knowledge of routing between Port and ECC. If it does just give the pins matching names.
We don't have to implement the entire design but the pieces we do create must be right for the larger context. With the current code the ECC/Cleanup PLL is not represented as a separate entity, and mapping of what source means is on the wrong "end" of the A.3 <> C.1 relationship.
The viable solutions are:
- Limit to the proposed "I drive the clock" vs "Someone drives it" and assume the Driver returns all info
- return the EEC Ref index, figure out which pin is connected to it and then check which MAC/PHY lane that drives it.
I assume option one is easy to implement and keep in the future even if we finally move to option 2 once we define EEC/DPLL subsystem.
In future #1 can take the lock information from the DPLL subsystem, but will also enable simple deployments that won't expose the whole DPLL, like a filter PLL embedded in a multiport PHY that will only work for SyncE in which case this API will only touch a single component.
Imagine a system with two cascaded switch ASICs and a bunch of PHYs. How do you express that by pure extensions to the proposed API? Here either the cleanup PLLs would be cascaded (subordinate one needs to express that its "source" is another PLL) or single lane can be designated as a source for both PLLs (but then there is only one "source" bit and multiple "enum if_eec_state"s).
I think we can't avoid having a separate object for ECC/Cleanup PLL. You can add it as a subobject to devlink but new genetlink family seems much preferable given the devlink instances themselves have unclear semantics at this point. Or you can try to convince Richard that ECC belongs as part of PTP :)
In fact I don't think you care about any of the PHY / port stuff currently. All you need is the ECC side of the API. IIUC you have relatively simple setup where there is only one pin per port, and you don't care about syncing the Tx clock.