From: Mark Brown broonie@linaro.org
The Arndale has a SMSC USB3503 connected in hardware only mode like a PHY, support it using the usb-nop-xceiv binding.
Note that due to a regrettable decision to use a regulator to represent the reset signal this uses a fixed voltage regulator to do that, there is a plan to use the reset controller binding once that is merged so it does not seem worthwhile to fix the usb-nop-xceiv driver at this point.
Signed-off-by: Mark Brown broonie@linaro.org Tested-by: Tushar Behera tushar.behera@linaro.org --- arch/arm/boot/dts/exynos5250-arndale.dts | 14 ++++++++++++++ 1 file changed, 14 insertions(+)
diff --git a/arch/arm/boot/dts/exynos5250-arndale.dts b/arch/arm/boot/dts/exynos5250-arndale.dts index 96d528d..2428ffd 100644 --- a/arch/arm/boot/dts/exynos5250-arndale.dts +++ b/arch/arm/boot/dts/exynos5250-arndale.dts @@ -539,4 +539,18 @@ rtc { status = "okay"; }; + + usb_hub_bus { + compatible = "simple-bus"; + #address-cells = <1>; + #size-cells = <0>; + + // SMSC USB3503 connected in hardware only mode as a PHY + usb_hub: usb_hub { + compatible = "smsc,usb3503a"; + + reset-gpios = <&gpx3 5 1>; + connect-gpios = <&gpd1 7 1>; + }; + }; };